*The price depends on type of a bathtub and a material it is made.

Many people daily have to put up with the trouble of searching for replacements for their old bathtubs. With this time consuming process, they waste a lot of energy and money that will not always provide them the satisfactory result in the end. However, Bathtub Refinishing will be able to get people exactly what they want and save them the trouble. Our company guarantees your bathtub a brand new look in less than 24 hours time.

Bathtub refinishing has easy steps to get the job done quick and does not require any effort for the customers. Depending on the circumstances, the job usually takes about 4 to 5 hours in total. When our specialists are done with the refinishing process, the bathtub is ready for use in 4 hours.

Bathtub replacing is difficult, costly, and time consuming. Replacing a bathtub takes more effort than just tearing off the old bathtub and placing a new one in the same spot. This process requires hiring a professional tile setter, a plumber, and even an electrician. However, that one is only one hassle of the many that you would be required to handle. In addition to hiring all of those people, you would have to find out if they have the necessary license for the job, and again search for a worker that will be able to get the job done better for less money. Not only is this a problem, but so are the noises, dirt, and other nuisances that go along with these remodeling projects.

Remember that we can do the job with only a fraction of the replacing process cost. When it comes to bathtub refinishing, we provide our customers with high quality work and 100% of our best effort to help you. Our specialists are here to guide you through the whole process in order for you to receive the bathroom look you have in mind. In just four to five hours, your bathroom will look and feel just as new or even better.

• First of all the refinishing process starts with preparing the workplace, special, strong abstergent is used for cleaning throughout the surface. The bathtub is scrubbed neatly removing any soap film and caulking, afterwards dried completely to prevent from moisture remains.
• The primer is followed by top coats. Their number may vary depending on a separate case but as a rule 3-4 coats are enough to reach a desired goal – customer satisfaction. HVLP Spray System allows us to spray acrylic polyurethane glaze with maximum high accuracy and quality.

• We spray two coats of Epoxy Primer over the bathtub to make perfection excellent!
• Special new method of etching the surface is used for delicate porcelain tubs, tiles and sinks that guarantees excellent look after the work is done. If you have marble, fiberglass tubs or sinks and are afraid them to get a pale color shade, there is nothing to worry about. Bonding agent and wet-dry sandpaper to "rough up" the surface is used in order to demonstrate the best possible result. These steps allow us to give a new birth to the tub. The surfaces to be glazed will also receive a solvent bath as part of the cleaning process.

NOTE. It takes approximately from 3 to 5 hours to do a standard bath restoration. The masking paper can be carefully removed and the tub re-caulked in 2 hours after. It is highly recommended from medical point of you not to take a bath in less than 24 hours after refinishing is done.